This command sets the minimum time between LSP transmissions.
| vlan all | Applies the timer configuration to all IS-IS VLANs. |
| vlan_name | Specifies a single VLAN to which the timer configuration applies. |
| milliseconds | Specifies the timer value. The range is 1 to 4294967295 milliseconds. |
33 milliseconds.
This is used to throttle LSP flooding. Higher values reduce network traffic and can help keep underpowered routers from becoming overloaded during network events. Lower values speed up convergence.
The following command sets the minimal LSP interval for IS-IS VLANs to 66 milliseconds:
configure isis vlan all timer lsp-interval 66
This command was first available in ExtremeXOS 12.1.
This command is available on platforms with a Premier license as described in the Switch Engine v33.1.1 Licensing Guide document.